need polypropylene tubes...
need polypropylene tubes...
and all I have are polystyrene.
:icon33:
:icon33:
-
- Posts: 17020
- Joined: Fri Dec 01, 2000 8:00 am
Re: need polypropylene tubes...
http://www.texloc.comwerldhed wrote:and all I have are polystyrene.
:icon33:
All your tubing needs met.
-
- Posts: 17020
- Joined: Fri Dec 01, 2000 8:00 am
Yeah. That's why I ran out -- I used up my whole stock. Polystyrene's amorphous crystaline structure causes it to become soft when I'm cooking the meth down, so I need polypropylene to get the job done. Unfortunately, I spent all weekend making meth, and now I don't have any tubes left for growing cloned super mutants. 

From my knowledge of plastics, polypropylene and polystyrene tubes are not heat temperable.
In shorth thay both become nothing but a melted mess when exposed to high heat.
Cooking crack will definatly make them melt, and even some of the ingrediants alone will make the tubes "unstable".
I could be wrong.
In shorth thay both become nothing but a melted mess when exposed to high heat.
Cooking crack will definatly make them melt, and even some of the ingrediants alone will make the tubes "unstable".
I could be wrong.

-
- Posts: 17020
- Joined: Fri Dec 01, 2000 8:00 am
-
- Posts: 17020
- Joined: Fri Dec 01, 2000 8:00 am
Ah, good ol' serendipity. It makes the world go round.chopov wrote:But with a bit luck..."
However, I have to follow standard protocol listed in my mutant cloning kit. Otherwise, someone willnotice that I used dirty tubes, and I'll have to discard my results since my samples were contaminated.
Then I'll never get a patent on my super mutants.
