Quake3World

Posted: **Tue Apr 21, 2015 12:28 pm**

I can't believe I can't find a tutorial on this anywhere... The only tutorial I can find is for a spiral staircase, like this http://www.katsbits.com/tutorials/idtec ... stairs.php

I want stairs like this:
[lvlshot]http://i744.photobucket.com/albums/xx87 ... /shot2.jpg[/lvlshot]

Anyone know the best way to make stairs like that?

Posted: **Tue Apr 21, 2015 12:36 pm**

Create 2 patch bevels for guidance and fiddle it together using the edge tool to align the brushes to the bevels.

Posted: **Tue Apr 21, 2015 2:15 pm**

I do it this Way:

2 Patches for guidance.
[lvlshot]http://i.imgur.com/GoYdE22.jpg[/lvlshot]

Then i use the clipper to cut the stairs.
[lvlshot]http://i.imgur.com/oHFN5lN.jpg[/lvlshot]

[lvlshot]http://i.imgur.com/mHrOdpE.jpg[/lvlshot]

[lvlshot]http://i.imgur.com/R6DIGMR.jpg[/lvlshot]

[lvlshot]http://i.imgur.com/d3z0VJH.jpg[/lvlshot]

[lvlshot]http://i.imgur.com/H4e3XD5.jpg[/lvlshot]

Im not good in writing tutorials but i hope this few pictures will help you!

Also i found this link:
http://panjoo.tastyspleen.net/curvedsta ... index.html

Posted: **Tue Apr 21, 2015 2:53 pm**

Yeah I figured using patches as guidance was the best way. Cheers

Posted: **Tue Apr 21, 2015 6:58 pm**

[lvlshot]http://i1187.photobucket.com/albums/z382/AndehGX/quake3/shot0000.jpg[/lvlshot]

Done

Posted: **Wed Apr 22, 2015 7:48 pm**

To me its always Pain to fit Trim to those round stairs!

Posted: **Thu Apr 23, 2015 1:42 am**

I would have just used a curve generator and modified it a bit

Posted: **Thu Apr 23, 2015 2:16 am**

Hmmm.. Generators.. Hmmm...

Posted: **Fri Apr 24, 2015 2:32 pm**

AndehX wrote:[lvlshot]http://i744.photobucket.com/albums/xx87/TheMuffinMan86/Radiant%20-%20Staircase%20Construction/shot2.jpg[/lvlshot]

The Edge forever

Curved stairs? (not spiral)