Quake3World.com
https://www.quake3world.com/forum/

FOG in a few brushes
https://www.quake3world.com/forum/viewtopic.php?f=10&t=54837		 Page 1 of 1
Author:  Fruity [ 02-02-2022 10:59 AM ]
Post subject:  FOG in a few brushes
Tries to insert the fog in the yellow boxes in the photo, but without the negative effect of transitions between consecutive fog brushes. As you know in Lava / Slime / water / you can use (watercault / slimecaulk etc) while the fog is different.
Inserting 1 fog brush will fix the problem, but the fog will be poured out of the walls.
1. What can you work around somehow errors caused by inserting the fog in 3 brushes next to each other of different sizes?
Or
2. Can I insert one fog brush with different polygon shapes?

Attachments:
1.jpg
1.jpg [ 83.66 KB | Viewed 148 times ]
Author:  Fruity [ 02-06-2022 09:40 AM ]
Post subject:  Re: FOG in a few brushes
I checked for a while and I would not do without changing the geometry of the terrain.
Author:  sst13 [ 02-08-2022 06:01 PM ]
Post subject:  Re: FOG in a few brushes
Fog is always a bit bitchy. I don't think fogs work correctly if the fog-brush has a non axial shape.

If the fog pit is not a perfect rectangle I use a tub made from caulk with the fog fitting perfectly inside. Then just 'dipping' the map into the tub.



But this doesn't solve your problem. :paranoid: :D

I remember darkly a turorial for multi-volume fog with some kind of fog caulk between the fog brushes. But I have never tried it and can't find anything about this method online. :(
Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/